Running You Own Localnet

To start a new weave, create a new data directory

mkdir -p localnet_data_dir

, create a wallet:

./bin/create-wallet localnet_data_dir

, and run:

$ ./bin/start-localnet init data_dir <your-data-dir> mining_addr <your-mining-addr>
storage_module 0,<your-mining-addr> mine

The given address (if none is specified, one will be generated for you) will be assigned 1_000_000_000_000 AR in the new weave.

The network name will be arweave.localnet. You can not start the same node again with the init option unless you clean the data directory - you need to either restart with the start_from_block_index option or specify a peer from the same Arweave network via peer <peer>. Note that the state is only persisted every 50 blocks so if you restart the node without peers via start_from_block_index before reaching the height 50, it will go back to the genesis block.

As with mainnet peers, each peer must be run in its own physical or virtual environment (e.g. on its own machine or in its own container or virtual machine). If you try to run two nodes within the same environment you will get an error like Protocol 'inet_tcp': the name [email protected] seems to be in use by another Erlang node

When POST'ing transactions to your localnet make sure to include the X-Network: arweave.localnet header. If the header is omitted, the mainnet network will be assumed and the request will fail.

Configuring localnet

See the localnet section in rebar.config for instructions on changing network constants for your localnet.